Manual PRO v.3
60 / 78
o
Connect the input line of the chlorinator directly to the
mains (single-phase or three-phase) depending on how
it’s been configured.
o
Remove the LK1 jumper to enable the start/stop mode.
Whith this configuration, the chlorinator will start the chlorine production when
the filtration pump is on, and will stop it
when it’s off while a “stop” m
essage is
shown on the display.
Figure 3.3: Auxiliary connection board
Cell cable connection
All the PRO series chlorinators are supplied with the cables already connected
to its power supplies.
Once the cells are installed, connect every power supply to its cell, using the
included hardware to attach it on every side of the cell.
