BSS Audio Omnidrive FDS-380, Руководство пользователя

Страница: 9 / 66

9
Refer to Section 2.6 'Installation' - AC Power and Fusing.
WARNING! THIS APPLIANCE MUST BE EARTHED.
IMPORTANT: The wires in the mains lead are colour coded in accordance
with the following code.
2.3 Mains Power
!
The wire which is coloured Green and Yellow or Green must be connected
to the terminal which is marked with the letter ‘E’ or by the Earth
signal or which is coloured Green and Yellow or Green.
"
The wire which is coloured Blue must be connected to the terminal la-
belled ‘N’ or coloured Black or Blue.
#
The wire which is coloured Brown must be connected to the terminal
labelled ‘L’ or coloured Red or Brown.
Those units supplied to the North American market will have an integral
moulded 3 pin connector which is provided to satisfy required local standards.
The mains voltage selector switch provides a simple external adjustment to
allow operation on all international AC power standards. The allowable ranges
for the supply voltage are:
99VAC up to 121VAC on the 120V position and
204VAC up to 264VAC on the 240V position.
An additional internal tap change is available for 100V working. Refer to
section 22.0; Service section. The tap change gives:
90VAC up to 110VAC on the 120V position
Outside these ranges the unit will not work satisfactorily, if at all. Voltages in
excess of the maximum will probably cause damage. Voltages below the
minimum will cause the power supplies to drop out of regulation, degrading
the performance of the system. The battery in the unit will preserve all data in
the event of a power failure.
Mains Power
Voltage Setting
Green and Yellow......Earth
Blue......Neutral
Brown......Live
As the colours of the wires in the mains lead may not correspond with
the markings identifying the terminals in your plug, proceed as
follows.
2.4 Voltage Setting