CRYSTAL CLEAN AIR
TM
4
BSE, Inc., 2246 Palmer Drive, Suite 108, Schaumburg, IL 60173
T: 866-360-5675 email:
@bsesales.com web: www.bsesales.com
Safety Instructions
WIRING
DANGER
High voltage electricity is required to operate this system.
Adhere to the National Electrical Codes and these instructions
when wiring into a BAS.
Turn the power off at the nearest disconnect before servicing
the equipment.
Properly size all circuit breakers or fuses.
WARNING
The information contained in this manual is intended for use
by an industry-qualified, experienced, certified electrician
familiar with the U.S. National Electric Code (NEC) who is
equipped with the proper tools and test instruments.
Ensure the unit is connected to a dedicated power source that
provides adequate power.
Refer to local, state, and federal codes, and use power wires
of sufficient current capacity and rating.
Secure all field wiring connections with appropriate wire
strain relief
Properly tighten all power connections.
OPERATION
DANGER
Do not block the inlet or outlet.
Do not provide power to or operate the unit if it is flooded
or submerged.
Do not allow water, dirt, or animals to enter the unit.
Do not operate the unit with the panel(s) or protective
cover(s) removed; keep fingers and clothing away from
moving parts.
Do not open the inlet grille of the unit during operation.
Removing or servicing the unit.
Periodically check power cable and connection for damage.
Use a dedicated power source for this product.
Do not operate the disconnect switch with wet hands.
Periodically verify the hanging bolts and other hardware
securing the unit have not deteriorated.
