BSDracing RAMPAGE XTE BS232R, Инструкция по эксплуатации

Страница: 5 / 11

Each part of the
transmitter
Steering control
This function is to control the direction.when
the steering turn to right then the front wheel
will turn to right (as picture),
when the steering turn to left then the front
wheel will turn to left(as picture).
Function lntroduction:
Adjust the dual rate of the steering by adjusting
the D/R knob.
Operation Method:
Throttle control
Function Introduction:
To control it by pushing and pulling back the
throttle trigger after power on.
This function is to control the throttle speed.
when pull the rhrotte trigger back.car will
accelerate forward(see the picture ),when push
the throttle trigger.the car will put on the brakes
or double ring asterm(according to the different
ESC)(see thepicture).
Operation Method:
Failsafe aims to prevent out-of-control driving
of RC car or RC boat. If the Receiver is not able
to receive any signal, from the control to throttle,
the parameter of throttle on receiver will turn
back to its original setting.
a.Turn on the Transmitter switch;
b.Turn on the Receiver switch. the LEDwill be
lighting;
c. Adjust Transmitter's Throttle, make the car/
boatto stop or flameout, then keep still.
d.Press the“Setting” button on Receiver (as the
pic below). the LEDwill be flashing, then stop
after 3seconds around, which means setting
finished.
a.Turn on the Transmitter switch;
b.Turn on the Receiver switch;
c. Turn off the transmitter switch;
d.Servo of throttle will turn back to its original
setting automaticlly’
e.Setting is successful if above procedures
finished completely.
Failsafe
Instruction
1.Function
ST TRIM
TH TRIM
ST D/R
POWER LED
POWER CHECK
ST REV
BIND KEY
TH REV
SWITCH
STEERING WHEEL
THROTTLE TRIGGER
BAT BOX
2.Setting
3.Testing