40
Appendix
Install Heart Rate Belt (Optional)
O
P EN
NOTE:
• In cold weather, wear appropriate clothing to keep the heart rate belt warm.
• The belt should be worn directly on your body.
• Adjust the sensor position to the middle part of the body (wear it slightly below the
chest). The Bryton logo shown on the sensor should be facing upward. Tighten the elastic
belt firmly so that it will not turn loose during the exercise.
• If the sensor cannot be detected or the reading is abnormal, please warm up for about 5
minutes.
• If the heart rate belt is not used for a period of time, remove the sensor from the heart
rate belt.
NOTE:
Improper battery replacement may cause an explosion. When replacing a new
battery, use only the original battery or a similar type of battery specified by the
manufacturer. Disposal of the used batteries must be carried out in accordance to the
regulations of your local authority.
For better environmental protection, waste batteries should be collected
separately for recycling or special disposal.
Strap
Electrodes
