Bruno CRE-2100, Руководство по установке

Страница: 31 / 68

31
©2004,1998 Bruno Independent Living Aids, Inc.®
CRE-2100 NRUL 08-16-2004
The interconnect circuit board provided on the CRE-2100 is equipped with diagnostic
modes that continuously monitor the operation of the stairway elevator. The circuit
board includes four (4) diagnostic modes to accommodate all types of installations.
When shipped from the factory, the circuit board is set in Mode #1.
Provides full range of audio diagnostic alerts:
* Circuit Board Power Up : Chirp
* Safety Device Activated : Chirp
* Stairlift Stopped Off Charge Bumper : 5 Beeps (4 short and 1 long)
Repeats every 3 minutes until stairway elevator is returned to bumper.
* Battery Voltage Drop : 5 Beeps (3 short and 2 long)
Repeats every 4 minutes until seat safety switch is disengaged,
battery voltage increases, or switch is pressed.
* Battery Voltage Critica l: 5 Beeps (2 short and 3 long)
Repeats once a minute until voltage is above 16 V
or switch is pressed.
* Switch Active During Power Up : 2 Beeps / Pause
Repeats beeps every 5 seconds until all switches are off.
* More Than One Switch Active: 2 Beeps / Pause
Repeats every 30 seconds until all switches are off.
Provides the same audio diagnostic notices as Mode #1 except for the Seat Safety
Disengaged alert. The unit will chirp one time only. No repeat alert.
None of the Audible Warning Messages are active.
Provides battery audio diagnostic only.
* Carriage Stopped Off Charge Bumper : 5 Beeps (4 short and 1 long)
Repeats every 3 minutes until carriage is returned to bumper.
* Battery Voltage Drop : 5 Beeps (3 short and 2 long)
Repeats once every 4 minutes until Seat Safety Switch is disengaged or
battery voltage increases.
* Battery Voltage Critical : 5 Beeps (2 short and 3 long)
Repeats once a minute until voltage is above 16 V.
Mode # 1: Multi-User / Diagnostic Mode
Mode #2: Single-User Mode
Mode #3: Quiet Mode
Mode #4: Battery Warnings Only Mode
CIRCUIT BOARD DIAGNOSTICS
ELECTRICAL