5
3 SOFTWARE INSTALLATION
USB DRIVER
The USB Driver is installed automatically when power is applied the first time. CLS-E Yoke
must show up in your Windows Device Manager as «Ethernet2CAN LC Gateway». To connect
the CLS-E Yoke to your simulation software, the CLS2Sim software needs to be installed
(Win32 application) on your windows based system or a windows virtual machine on LINUX or
MAC. X-Plane Plugins for MAC & LINUX can be found here:
https://www.brunner-innovation.swiss/product/cls2sim-software/
CLS2SIM (v3.18 Patch 9 or later)
Download SW from
http://www.brunner-innovation.swiss/media
PLEASE NOTE:
CLS2SIM SW NEED TO BE USED FOR MAPPING X- (ROLL)
AND Y- (PITCH) AXIS, NOT YOUR SIMULATION SW APPLICATION! THE YOKE
BUTTONS CAN BE CONNECTED TO DEDICATED FUNCTIONS IN YOUR
SIMULATION SOFTWARE VIA USB VIRTUAL DRIVER (VJOY) OR VIA CLS2SIM
SOFTWARE. FOR ADDITIONAL INFORMATION, PLEASE VISIT http://cls2sim.brunner-innovation.swiss/
DUAL YOKE SETUP / SYNCHRONIZATION
In case of using 2 CLS-E Yokes (MCC Configuration), the pilot and copilot
device ID must be entered via the CLS-E Yoke Display Menu.
Information can be found in the extended manual under
http://www.brunner-innovation.swiss/media/.
After entering the ID’s, connect a standard RJ45 Cat5 Ethernet cable on
the “CANopen” connector between the units. All necessary settings for
self-synchronization are done automatically.
Please read the Help-File (F1 in CLS2Sim) for further information or
contact us at [email protected]
