Issued:
Tested:
Revised:
Status: 300 Approved
Page 22 of 33
Ralph Moretti
Michel Benkovics
Ralph Moretti
Document number:
Index
10.07.2015
17.07.2015
20.01.2022
235.01518
CA
8.1
Fault removal
The machine is basically very robust, so that faults are rare. The following instructions may help you
nonetheless:
First action to take for any faults: Switch off the machine! Pull the plug immediately should you detect
any unpleasant odours.
8.2.1
Unit is not working:
1.
Check the plug’s function by connecting a different device.
2.
Check the microfuse. The fuse protects the circuit amplifier from any voltage surges or se-
vere fluctuations. This is located below the machine next to the cable outlet.
3.
If the machine continues to malfunction, please contact a technician or the Brun-
ner-Anliker Customer Service.
Figure 16:
Underside of the machine
Item
Item
1 Type plate
3 Mains cable
2 Microfuse
Table 3:
Underside of the machine
8.2.2
Clogging
Nothing goes in - nothing comes out. Switch off the machine, dismantle and clean. Refer to
point 7
8.2.3
Hopper head refuses to close
When using PG and BR discs, the hopper head may no longer close as the tappet / pin is
placed on the disc directly underneath the driver. Open the hopper head and slightly rotate
the disc. You should now be able to close the hopper head.
8.2.4
Cutting insert W cannot be removed.
The bayonet lock was not unlocked correctly. Rotate and hold the cube blade carefully in
anti-clockwise direction so that the bayonet lock is unlocked and both parts can be simulta-
neously lifted out from below.
