© Brüel & Kjaer Vibro GmbH
/
2 mm ds822 ATEX /8.12.16/technical specifications subject to change/C105507.001/V02
l
15
EN
4.2.1 Mounting on hat-rail
*For mounting on a hat-rail, the mounting tabs for screw mounting can be separated at the predetermined breaking point.
1.
For screw mounting, break off both tabs and attach the driver with the assembly adapter by
sliding it into place
(figure
)
.
2.
Affix the assembly adapter to a hat-rail (DIN EN 60715 TH35):
Place rear part of the assembly adapter (see figure above, item A) onto the guides of the
hat-rail and press driver and adapter downwards until the adapter clicks into place (figure
).
You need to secure the installed driver against misalignment with hat-rail end clamps.The hat-
rail end clamps are included with our recommended protective driver housings AC-2108 for up
to 3 drivers, and AC-2109 for up to 6 drivers.
1
*
2
A
