BRP Lynx Commander GT 1200 4-TEC Comfort, Руководство оператора

Страница: 99 / 164

MAINTENANCE PROCEDURES
fmo2016-003-012_b
PIVOT THE ACCESS COVER
1. Retaining screws
5. Clean drain plug area.
6. Place a drain pan under the bottom
pan opening.
7. Remove engine drain plugs in the
following order.
7.1 Main drain plug.
7.2 Secondary drain plug.
mmr2011-070-053_a
UNDERNEATH THE ENGINE
1. Main drain plug
2. Secondary drain plug
8. Allow oil to drain completely.
9. Install NEW sealing washers on oil
drain plugs.
NOTICE
Never use a sealing
washer a second time. Always re-
place with a new one.
mmr2011-070-004_a
1. Sealing washer
2. Oil drain plug
10. Install drain plugs and tighten to
the specified torque.
DRAIN PLUGS TIGHTENING TORQUE
20 N•m ± 2 N•m (15 lbf•ft ± 1.5 lbf•ft)
11. Replace
OIL FILTER
, see proce-
dure in this subsection.
12. Refill oil tank at the proper level
with the recommended oil.
APPROXIMATE ENGINE OIL
CAPACITY (WITH FILTER)
3.3 L (3.5 qt (U.S. liq.))
13. Reinstall dipstick in oil tank and
properly tighten it.
14. Start engine and let it idle for a few
minutes.
15. Ensure there are no leaks.
16. Stop engine and check oil level as
explained in this subsection. Refill
if necessary.
17. Dispose oil and filter as per your lo-
cal environmental regulations.
Engine Oil Replacement
(1200 4-TEC)
WARNING
The engine oil can be very hot.
Wait until engine oil is warm.
_______________
97