BRP Lynx Commander GT 1200 4-TEC Comfort, Руководство оператора

Страница: 102 / 164

MAINTENANCE PROCEDURES
– Oil filter cover with O-ring
– Oil filter.
mmr2009-111-006_a
1. Oil filter cover screws
2. Oil filter cover
3. O-ring
4. Oil filter
5. Dispose filter as per your local envi-
ronmental regulations.
Oil Filter Installation
1. Check the oil filter inlet and outlet
orifices inside oil filter receptacle
(integrated part of magneto cover)
for dirt and contaminations.
mmr2009-111-007_a
1. Oil inlet orifice from the oil pressure pump
2. Oil outlet orifice to the engine lubrication
system
3. Oil filter receptacle
2. Install a NEW O-ring on oil filter
cover.
3. Lubricate filter seal and cover O-ring
with engine oil.
mmr2009-111-008_a
1. Lubricate with engine oil
4. Install the oil filter cover.
5. Tighten oil filter cover screws to the
specified torque.
OIL FILTER COVER TIGHTENING
TORQUE
10 N•m ± 1 N•m (89 lbf• in ± 9 lbf• in )
6. Install muffler.
Exhaust System
Exhaust System Verification
The tail pipe of the muffler should be
centered with the exit hole in the bot-
tom pan. Exhaust system must be
free of rust or leaks. Make sure that all
parts are securely in place.
Check retaining springs condition and
replace if necessary.
The exhaust system is designed to re-
duce noise and to improve the total
performance of the engine. Modifica-
tion may be in violation of local laws.
NOTICE
If any exhaust system
component is removed, modified
or damaged, severe engine damage
may result.
Spark Plugs
Spark plugs inspection or replace-
ment must be done by an authorized
Lynx dealer, repair shop, or person of
your own choosing. Spark plugs in-
spection or replacement requires an
in-depth technical knowledge due to
the E-TEC direct fuel injection technol-
100
______________