BRP Lynx Commander GT 1200 4-TEC Comfort, Руководство оператора

Страница: 76 / 164

OPERATING MODES (900 ACE AND 1200 4-TEC)
Learning Key Modes
The learning key provides a mode of
operation whereby engine torque and
speed are limited.
NOTE: The initial learning key pro-
gramming can limit the speed
to 40 km/h (25 MPH) or 70 km/h
(43 MPH). Refer to your authorized
Lynx dealer to modify this setting.
There are 3 levels available for the
learning key mode.
Changing Learning Key Settings
To change learning key setting, carry
out the following:
1. Press the START/electronic reverse
button to wake up the electrical sys-
tem and install the NORMAL key on
the engine cut-off switch.
2. Wait for the information center to
complete its self-test and display
the key recognition message.
3. Press the MODE button once, then
press the SET button until LEARN
is visible in the digital center of the
gauge.
mmo2014-004-001_f
MULTIFUNCTION GAUGE
1. MODE function
2. SET function
4. Use the heated grip switch to toggle
the key setting between 1 and 3.
mmo2014-004-002_a
TYPICAL
1. Heated grip switch
2. Increase
3. Decrease
NOTE: Setting 1 is the lowest avail-
able torque, while setting 3 is the high-
est available torque for learning key.
5. After a few seconds, the setting is
automatically confirmed and saved.
NOTE: The key speed setting is appli-
cable to any key of the same type used
on a specific snowmobile. The same
key type used on a different snowmo-
bile may therefore have a different key
speed setting.
NOTE: Vehicle performance may vary
depending on riding conditions.
74
______________