MULTIFUNCTION GAUGE MESSAGES
MESSAGE
PILOT
LAMP(S) ON
DESCRIPTION
BAD KEY
Check engine
Indicates that you have used the wrong D.E.S.S. key, use the
proper key for this vehicle.
DESS KEY NOT
RECOGNIZED
Check engine
Indicates that there possibly is a bad contact, remove and clean
key.
PARK BRAKE
Parking brake
Displayed when brake is applied for more than 15 seconds
(while riding).
LO BATT VOLT
Check engine
Low battery voltage, check battery voltage and charging
system.
HIGH BATT VOLT
Check engine
High battery voltage, check battery voltage and charging
system.
LOW OIL
(1)
Check engine
Engine low oil pressure, stop engine immediately.
HI TEMP
Check engine
Engine is overheating, refer to
ENGINE OVERHEATS
in
TROUBLESHOOTING
section.
LIMP HOME
Check engine
Serious fault on the engine that can change the normal
operation of the engine, CHECK ENGINE indicator lamp will
also blink, refer to
TROUBLESHOOTING
section.
CHECK ENGINE
Check engine
Engine fault, CHECK ENGINE indicator lamp will also be ON,
refer to
TROUBLESHOOTING
section.
ECM NOT
RECOGNIZED
Check engine
Communication error between speedometer and engine control
module (ECM).
CHECK DPS
Check engine
Indicates that the DPS (Dynamic Power Steering) does not work
properly.
MAINTENANCE
REQUIRED
(2)
None
Displayed in gauge when vehicle is due for a maintenance
TPS FAULT PRESS
OVERRIDE BUTTON TO
LIMP HOME
Check engine
Throttle position sensor does not work properly. Seek service
from an authorized Can-Am dealer, repair shop or person of your
own choosing for maintenance, repair or replacement. Please
refer to the US EPA Emissions-related warranty contained
herein for information about warranty claims.
NOTICE
(1)
If the message and the check engine light stay on after engine
starting, stop engine. Check engine oil level. Refill if necessary. If the oil
level is good, seek service from an authorized Can-Am dealer, repair shop
or person of your own choosing for maintenance, repair or replacement.
Please refer to the US EPA Emissions-related warranty contained herein for
information about warranty claims. . Do not use the vehicle until repaired.
(2)
To erase the MAINTENANCE REQUIRED message, proceed as follows:
1. From main display (vehicle speed), press SET and HOLD.
2. Alternate between LOW beam and HIGH beam 3 times.
NOTE:
Step 2 must be completed within
2 seconds
.
3. Release SET button.
176
______________
Содержание CAN-AM OUTLANDER 6x6 2017 Series
