Browlee-Morrow Vulcan Pumps HDS 100L, Инструкция по установке, эксплуатации и обслуживанию

Страница: 33 / 51

Document No. – A1540 Date – 23 January 2014 Revision – 0
Uncontrolled Copy
30
6.0 Trouble Shooting
6.1 Fault Tracing
Use the following fault tracing logic to aid in troubleshooting the pump and motor; it is assumed
that the pump has been previously operating without any problems. Fault tracing should be
performed by a licensed Electrician and should conform to all regional and industry specific
electrical standards. In order to properly carry out fault tracing a multi-meter, test lamp and
wiring diagram must be used.
For the electric submersible motor installation, operation and maintenance refer to:
Baldor® - Reliance® AC Submersible Motors
Installation & Operation Manual, MN414
6.1.1 Pump Does Not Start
WARNING!
Is there Power
to the Motor?
Check:

Main Input Power

Control Equipment Power

The Main Switch is in the OFFposition

Main Fuses

Each Phase Voltage

Overload Reset

Open Circuits

Ground Circuit
Yes
No
Can the pump
be started
manually?
Check:

Motor Temperature Fault

Moisture Sensor Fault

Pump is jammed with debris
10 STARTS & STOPS MAXIMUM / HR!
No
Yes
Check:

Level Control Equipment

Faulty Control Equipment
ALWAYS LOCKOUT & DISCONNECT POWER TO THE ELECTRIC
MOTOR BEFORE PERFORMANING ANY MAINTENANCE
!