Browlee-Morrow Vulcan Pumps HDS 100L, Инструкция по установке, эксплуатации и обслуживанию

Страница: 20 / 51

Document No. – A1540 Date – 23 January 2014 Revision – 0
Uncontrolled Copy
17
Once the pump has found a stable operating condition, monitor the motor amperage draw. If
possible monitor the pump discharge pressure and flow rate. It is recommended that amperage
draw, discharge pressure and flow rate readings be recorded frequently to identify any changes
in the pump performance that could indicate possible problems with the pump or motor.
CAUTION!
CAUTION!
CAUTION!
4.3 Pump Shut Down
CAUTION!
Always flush the entire discharge line with clean liquid prior to shutting down the pump.
4.3.1 Pump Standby - Cold Temperature Applications
If the pump is removed from the sump when it is not being used, ensure the following:
1. Drain all of the liquid from the wet end components, water jacket, jet ring and piping.
Water expands when it freezes and can cause damage to equipment.
2. The oil in the motor seal cavity can thicken during standby and some of the elastomers
must not be operated in cold temperatures. Ensure that the pump is pre-heated prior to
start-up.
OPERATING THE PUMP WITHOUT CLEANING OUT THE SUMP PRIOR
TO INSTALLATION MAY CAUSE DAMAGE TO THE PUMP ASSEMBLY!
ALWAYS CALCULATE THE SLURRY SYSTEM OPERATING POINT
PRIOR TO PURCHASING OR INSTALLING A PUMP!
ALWAYS CHECK THE MOTOR AMPERAGE DRAW TO ENSURE THE
MOTOR IS NOT BEING OVERLOADED?
NEVER STOP THE PUMP WHILE SOLIDS ARE IN THE DISHCARGE
PIPE!