Brother PT-9200PC, Руководство по обслуживанию, Страница: 46 / 93

II - 34
PT99007
[4] Reassembly of the Cutter Assy, the Half Spacer, the Half Cutter Assy,
and the Eject Unit Assy
(1) Apply the specified grease (3 mm
3
) on each slot of the cams in the cutter
assy and the eject unit assy, where the cutter rock pin slides up and down.
(Specified grease: Silicone grease G501)
(2) After inserting the cutter rock pin into the groove in the movable blade of the
cutter assy, insert the two locating shafts of the frame assy into the round
and oblong holes.
Warning : Take care not to be injured by the blades of the cutter assy and
the half cutter assy.
(3) Insert the two locating shafts of the frame assy into the round and oblong
holes in the half spacer.
(4) After inserting the half rock pin of the half cutter assy into the groove in the
half rock gear, insert the two locating shafts of the frame assy into the round
and oblong holes.
(5) After setting the eject cam of the eject unit assy on the cutter rock pin, insert
the two locating shafts of the frame assy into the round and oblong holes.
(6) While pressing the vicinity of the screws to be tightened on each of the above
four units, tighten the two screws.
Mechanical unit
Cutter rock pin
Two screws
Half cutter assy
Eject unit assy
Half spacer
Cutter assy
(Full cutter assy)
Locating shafts
Cutter rock pin
Fig. 2.2-43 Reassembly of the Cutter Assy, the Half Spacer,
the Half Cutter Assy, and the Eject Unit Assy