EDITING A LABEL
24
Selecting a Labelling Application Type
PUNCH-DOWN BLOCK
Labels printed with this mode can be used to identify a type of electrical connection often
used in telephony. There are up to three lines for each block on a single label and you can
enter three lines for each block. In this mode, you can specify the following settings:
• Module Width:
200mm
, 50mm-300mm
• Block Type:
4 Pairs
, 2 Pairs, 3 Pairs, 5 Pairs, Blank
• Sequence Type:
(None)
,
(Horizontal),
(Backbone)
• Start Value:
---
, 1 - 99999
Heat Shrink Tube
When using Heat Shrink Tube, the HEAT-SHRINK TUBE setting screen
appears when any of the labelling application type keys is pressed.
Label length:
Auto
, 25mm-999mm
When using Heat Shrink Tube with a width of 5.8 mm or 8.8 mm,
the maximum printing length is 500 mm.
Text: Type in one or more lines of data.
Setting Cross-ID
When creating Cable Wrap or Cable Flag, you can make the Cross-ID printed labels.
Press the
Cable Wrap
or
Cable Flag
key.
Select “Cross-ID” using the or key.
Select “On” to using the or key.
One line: Enter the text and insert “/” or “\” where you want to apply the Cross-ID.
Two lines or more: You can apply the Cross-ID between the lines by pressing the
Enter
key to create another line.
• When “Blank” is selected in “Block Type”, “Sequence Type” is set to None.
• When “None” is selected in “Sequence Type”, “Start Value” shows “---” and you cannot
set a value. To set the “Start Value” from 1 to 99,999, select either “Horizontal” or
“Backbone”.
When using Heat Shrink Tube:
• You cannot print frames.
• Portions of some decorative characters may be cut off when a line is broken.
• The printed characters may be smaller than when using TZe tape.
1
2
1 line
2 or more lines
Example:
3
44
Содержание P-touch E550W
Страница 91: ......
