EDITING A LABEL
6
Selecting a Labelling Application Type
PUNCH-DOWN BLOCK
Labels printed with this mode can be used to identify a type of electrical connection often
used in telephony. There are up to three lines for each block on a single label and you can
enter three lines for each block. In this mode, you can specify the following items.
• Module Width:
200mm
, 50mm-300mm
• Block Type:
4 Pairs
, 2 Pairs, 3 Pairs, 5 Pairs, Blank
• Sequence Type:
(None)
,
(Horizontal),
(Backbone)
• Start Value:
---
, 1 - 99999
Heat Shrink Tube
When using Heat Shrink Tube, the HEAT-SHRINK TUBE setting screen
will be displayed when any of the labelling application type keys is
pressed.
• Label length:
Auto
, 25mm-999mm
However, the maximum printing length is 500 mm when using Heat Shrink Tube with a
width of 5.8 or 8.8 mm.
Text: Type in single or multiple lines of data.
Setting Cross-ID
When printing Cross-ID labels, use the
Cable Wrap
and
Cable Flag
keys.
Press the
Cable Wrap
or
Cable Flag
key.
Select "Cross-ID" using the or key.
Select "On" to set Cross-ID by using or key.
1 line: Enter the text and insert "/" or "\" where you want to apply Cross-ID.
2 or more lines: You can apply Cross-ID between lines by pressing
Enter
key to create
another line.
• When “Blank” is selected in “Block Type”, “Sequence Type” is set to None.
• When None is selected in “Sequence Type”, “Start Value” shows “---” and you
cannot set a value. Selecting Horizontal or Backbone however, allows you to set
the “Start Value” from 1 to 99,999.
When using Heat Shrink Tube:
• You cannot print frames.
• Portions of some decorative characters may be cut off when a line is broken.
• The printed characters may be smaller than when using TZe tape.
1
2
For example:
1 line
2 or more lines
3
44
Содержание P-touch E500
Страница 63: ......
