Brother FAX-615, Руководство по обслуживанию

Страница: 40 / 123

IV – 1
1. INDICATION AND PRINTOUT OF ERROR
To help the user or the service personnel promptly locate the cause of a problem (if any), the
facsimile equipment incorporates the self-diagnostic functions which display error messages
for equipment errors and communications errors.
For the communications errors, the equipment also prints out the transmission verification re-
port and the communications list.
2. EQUIPMENT ERROR
If an equipment error occurs, the facsimile equipment emits an audible alarm (continuous beep-
ing) for approximately 4 seconds and shows the error message on the LCD. For the error
messages, see Section 2.1. As one of the error messages, “MACHINE ERROR xx” includes
an error code which indicates the detailed error causes listed in Section 2.2. To display an error
code for other latest error message, make the equipment enter the maintenance mode and
press 8 and 2 keys (for details, refer to Chapter
V , Subsection 3.3.9).
2.1 Error Messages on the LCD
Messages on the LCD Probable Cause
PAPER ROLL EMPTY The paper empty (PE) sensor detects that no recording paper
is present.
PRINTER JAM The recording paper failed to return to the printing position after
it had been cut.
COVER OPEN The cover sensor detects that the the recording paper cover is
not closed.
DOCUMENT JAM
■
Document jam
(1) The document length exceeds the limitation (400 or 90 cm)
registered by firmware switch WSW16. (Refer to Chapter
V, Subsection 3.3.5.)
(Both the document front and rear sensors stay ON after
the document has been fed by the registered length.)
(2) The document rear sensor detects no trailing edge of a
document after the document has been fed by 400 cm.
(The document rear sensor stays ON even after the
document has been fed when the document front and rear
sensors were OFF and ON, respectively.)