160
Programmer
Chapter 3 Programming with Command Function
Moving to position 1
1.
Press
and press
.
The work clamp moves from the start point by
each stitch.
2.
Press
when the needle is at 1.
The work clamp stops. If the work clamp passes,
input a few stitches and press
. The needle
returns for a few stitches of the input.
Moving in parallel
1.
Press
and press
.
Input the command for parallel movement.
2.
Move the work clamp with
. Press
when the needle point is at 2 of the pattern.
If pattern C is present after pattern B, pattern C is
automatically moved in parallel. If this is not
preferred, move pattern C in parallel as in steps
“Moving to position 1” and “Moving in parallel” or
“Moving a part of continuous program in parallel
partially” in chapter 2.
Saving
1. Specify the program number on the operation
panel and press the read/write switch for writing
into the floppy disk.
Ending program
1.
Press
.
Содержание BAS-300F Series
