Brother 888X Series, Руководство по обслуживанию

Страница: 44 / 70

3 - 7
Adjust
ment
Adjustment
Adjustment Needle swing timing
[Standard]
At the maximum width zigzag stitch of pattern selecting dial, when the needle bar starts
oscillating movement from left to right, the distance from the needle plate top surface to
the needle point should be more than 6.5 mm.
* When the needle bar stops oscillating movement from left to right, the distance
from the needle plate top surface to the needle point should be more than 6.5
mm.
[Confirmation]
1. When the pulley is turned by hand from the rear to the front, check that the needle flow from left to right is
normal. And check that the upper shaft rotation is not too heavy.
*Key point
• If you find any error in needle swing timing, reattach the upper shaft to engage markings on the upper shaft
gear and the pattern cam.
* Refer to
“2-18” .
Starting position
of lateral motion Stopping position
of lateral motion
More than 6.5 mm More than 6.5 mm
Needle plate
* The needle does not move to left/right direction under the needle plate.
[ OK ]
Needle plate
* The needle moves to left/right direction under the needle plate.
Upper shaft gear
Pattern cam
Upper shaft
[ NG ]