Brother 888-F42, Руководство по эксплуатации

Страница: 90 / 120

Reinforcement Stitching
S-36
Reinforce points that will be subject to strain, such as sleeve
holes, inseams and pocket corners.
Triple stretch stitching
Use triple stretch stitching to reinforce sleeve holes and
inseams.
a
Attach zigzag foot “J”.
b
Select stitch .
c
Start sewing.
Bar tack stitching
Bar tacks are used to reinforce points subject to strain, such as
pocket corners and openings.
As an example, the procedure for sewing bar tacks at pocket
corners is described below.
a
Determine the desired length of the bar tack.
Set the button guide plate on buttonhole foot “A” to the
desired length. (The distance between the markings on
the presser foot scale is 5 mm (3/16 inch).)
1
Presser foot scale
2
Length of bar tack
3
5 mm (3/16 inch)
• A bar tack with a maximum length of about 28 mm
(1–1/8 inches) can be sewn.
b
Attach buttonhole foot “A”.
c
Select stitch .
d
Position the fabric so that the opening of the pocket
faces toward you, and then lower the presser foot lever
so that the needle drops 2 mm (1/16 inch) in front of
the pocket opening.
1
2 mm (1/16 inch)
Pass the upper thread down through the hole in the
presser foot.
• When lowering the presser foot, do not push in the
front of the presser foot, otherwise the bar tack will
not be sewn with the correct size.
1
Do not reduce the gap.
Reinforcement Stitching
Stitch name Stitch Stitch number Presser foot
Triple stretch stitch 5 J
Darning stitch 39
A
Bar tack stitch 40
J
3
1
2
1
a