Brother 888-F42, Руководство по эксплуатации

Страница: 71 / 120

Buttonhole Stitching/Button Sewing
Sewing S-17
U
T
IL
ITY S
T
IT
CH
ES
S
b
It fits into the grooves, and then loosely tie it.
c
Attach buttonhole foot “A”.
d
Select stitch or .
e
Adjust the stitch width to the thickness of the gimp
thread.
f
Lower the presser foot lever and the buttonhole lever,
and then start sewing.
g
When sewing is finished, gently pull the gimp thread to
remove any slack.
h
Use a handsewing needle to pull the gimp thread to the
wrong side of the fabric, and then tie it.
Button sewing
Buttons can be sewn on with the machine. Buttons with two
or with four holes can be attached.
a
Measure the distance between the holes in the button
to be attached.
b
Raise the presser foot lever, and then slide the feed dog
position switch, located at the rear of the machine on
the base, to
(to the left as seen from the rear of
the machine).
1
Feed dog position switch (as seen from the rear of the
machine)
c
Attach button fitting foot “M”.
d
Select stitch .
• Since the end of the thread will be tied off later, do
not set the machine for programmed thread cutting.
e
Adjust the stitch width so that it is the same as the
distance between the holes in the button.
f
Place the button in the position where it will be sewn,
and lower the presser foot lever.
1
Button
• When attaching four-hole buttons, first sew the two
holes closest to you. Then, slide the button so that
the needle goes into the two holes toward the rear of
the machine, and then sew them in the same way.
a
a