Endure Balanced Flue
11
Assembly – Flue Pipe
6. Once the correctly sized flue hole has been made, offer the appliance up in order
to mark the position for the four bracket arms. These positions will need to be
drilled and plugged using suitable fixings (not supplied).
7. Test fit the flue pipe to the burner assembly and wall; it is possible to trim down
the provided flue pipe. Once the final position of the appliance has been
established (and the flue pipe trimmed if necessary) secure the flue pipe to the
burner assembly as shown below.
8.
Ensure there is an air tight seal between the spigot and flue pipe.
9.
Position the burner assembly into its final position taking care not to damage the
flue pipe as it passes through the wall. Outside the property secure the wall plate
to the flue pipe and seal the plate against the brickwork using morter or high
temperature sealing compaond.
10.
Make any final adjustments to the four adjustable burner bracket arms and ensure
the fixings are tightend on each arm. Fix each of the arms against the rear wall
using appropriate heat-proof fixings (not supplied).
