Broseley eVolution 4, Руководство по установке и эксплуатации

Страница: 6 / 33

6
eVo 4&7 Inset MS07 ‐ 11 11/07/11
BURNING WOOD IN A SMOKE CONTROL AREA.
The eVolution Inset Wood burning stoves have been testedby GASTEC under the PD6434 standard and
have passed the emission requirements for exemption under the Clean Air Act. Subsequently it has been
exempt for use in smoke control areas when burning wood only
Below are detailed operation techniques that must be adhered to at all times when burning in a
smoke control zone.
eVo 7 Inset
Refueling
The refueling procedure adopted for the PD6434 tests allows the newly charged fuel to burn with the
door set on the latch but not closed, the primary control set fully open for 1 ‐ 2 minutes and the
secondary air set in the required positions necessary for the various outputs. After 1 ‐ 2 minutes, with
the logs burning well, the door and primary air supply needs to be closed but the secondary air control
position can remained unaltered. The tertiary air supply is maintained with its permanent opening
throughout.
Ignition
The procedure adopted for ignition is to build a bed of embers in stages with the objective of warming
the stove as quickly as possible. Firstly, a double ‐ handful of kindling (equivalent to the weight of about
1 kg) should be lit with chemical firelighters. The primary air and secondary air controls must be fully
open at this stage. The fire ‐ door needs to be pushed against the latch but not closed, leaving a gap of a
few millimeters. After about 8 minutes, with the fire bed dying back, 3 half ‐ sized logs (total weight
about 1.2 kg) should be added with the air controls unaltered. After approximately a further 2 minutes,
when these logs are well alight the door and primary air supply can be closed. Then allow the fire to
burn down to embers with the secondary air supply maintained at maximum, at which point the ignition
sequence is deemed to have ended.
eVo 4 Inset
Refueling
There is a requirement for the door to be left ajar for 3 minutes immediately after refuelling. This is to
ensure that flames are well ‐ established on the newly charged logs and that they become fully
blackened. Additionally, for medium and low output burning, the Secondary air control must be
maintained at 100% open for the first 3 minutes after refuelling at which time it is possible to adjust to
the required settings as identified above. The primary air intake is not required at this stage.