Broseley eVolution 4, Руководство по установке и эксплуатации, Страница: 28 / 33

28
eVo 4&7 Inset MS07 ‐ 11 11/07/11
Where there is no direct and sealed connection to the chimney or chimney liner
(where fitted) it is essential that the fire is sealed to the surround and the
hearth using fire cement for a gas ‐ tight seal in accordance with BS 8303 ‐ 1.
Fitting the stove eVo4 Inset
Remove the flue pipe adaptor (if fitted) Insert the stove into the fireplace opening ensuring that the
rope forms an airtight seal against the fireplace and hearth. Secure the stove with screws (not supplied
as they need to be suitable to screw into the hearth material) into the hearth through the holes located
inside the stove – holes ‘A’ and ‘B’. There are two holes located on the left and right hand side and one
hole located in the middle of the stove. You should use all 3 holes to secure the appliance as holes not
used will ensure excess air enters the combustion chamber which can cause issues with the air wash.
If all holes are not used they must be blocked with silicone or firecement.
Then use the chimney clamp (C) to hold the top of the appliance against the fireplace opening ensuring
again that an airtight seal is formed. It may be a requirement to drill a clearance hole through the
chimney breast on some installations for clamp C.