2022/01/06
FT1020G3 Quick Operation Guide
Page
1
of
6
FIRETRACKER FT1020G3 - QUICK OPERATION
GUIDE
1 - TO SILENCE PANEL BUZZER:
Press
Button once to silence panel buzzer.
2 -TO SILENCE ALARM DEVICES:
Press
Button once to silence all alarm devices, Occupant Warning System
(OWS) or sounders and wait for a few seconds.
Pressing the
Button again will cause the alarms to resound.
3 - TO RESET FIRE ALARM:
IMPORTANT: Alarm devices must be silenced before pressing “Reset” button.
Press and hold the
Button for 1 second until the Fire Alarm Panel starts its
reset sequence. The system will now automatically reset all alarms.
Alarms may re-trigger in the system if the alarm condition is still present. Wait for 30 seconds
and try again.
4 - TO DISABLE (ISOLATE) AN ACTIVE ALARM:
IMPORTANT: Alarm devices must be silenced before pressing “Disable” button.
Press
Button to isolate device in alarm (H2/B1)
– system will now illuminate
the
LED. This zone / address point will remain disabled until
manual re-enabled via Menu H2/B1 button.
