9.17.148 A
2
Introduction
Intended use
The ES-FLOW™/GEMÜ 650 Liquid Dosing Set has been developed to accurately measure and control volume flow rates in a fluid
system, using the media and operating conditions (e.g. temperature, pressure) as specified at ordering time.
Any other use than mentioned here is considered unintended.
Bronkhorst High-Tech B.V. cannot be held liable for any damage and/or injury resulting from unintended, improper or unsafe use,
or use with other media and/or under other conditions than specified.
Scope of this guide
This document contains general assembly instructions for the
Liquid Dosing Set
ES-FLOW™/GEMÜ 650
(LDS). It does not in any
way replace the manuals for the individual components; for correct installation, operation and maintenance the respective
manuals are indispensable.
Scope of delivery
Art. no.
Physical items:
·
ES-FLOW™ Ultrasonic Volume Flow Controller
7.11.674
·
GEMÜ 650 MG8 Diaphragm Valve (control valve)
2.17.421 / 422 / 423
·
Festo VEAA Proportional Pressure Regulator (pilot valve)
2.17.424
·
Festo 4 mm OD Push Fitting
2.04.804
·
Actuation cable 4-pin M8 male/female, 1 m
7.03.764
Documentation:
·
Manual ES-FLOW™ Ultrasonic Volume Flow Controller
9.17.145
·
Manual GEMÜ 650 Diaphragm Valve (operating instructions)
-
·
Manual Festo VEAA Proportional Pressure Regulator
-
·
The ES-FLOW™ manual can be downloaded from the www.bronkhorst.com website
(
www.bronkhorst.com/downloads/
).
·
The manuals for the control valve and the pilot valve can be downloaded from the websites of their respective
manufacturers.
Additional accessories (not included)
·
flexible tube 4 mm OD
·
3x Tri-Clamp clamp matching the individual components
·
3x matching Tri-Clamp gasket
