© 2020 Bronkhorst High-Tech B.V.
3
Safety precautions
Please read this document entirely and carefully before installing and operating the equipment. Not following
the guidelines could result in personal injury and damage to the product and the system(s) it is incorporated in or
connected with.
General
·
The product(s) described in this document may only be used by qualified personnel who are familiar with combined
fluid and electrical systems and who recognize the associated hazards (e.g. (high) fluid pressure, electric shock).
·
The end user is considered to be familiar with the required safety precautions to prevent damage and/or injury while
working with the process media (as described in the associated Material Safety Data Sheets) and the equipment.
·
The end user is responsible for taking the necessary safety precautions and proper use of appropriate (personal)
protective equipment.
·
The equipment and its accessories must be used in accordance with their intended use, specifications and operating
instructions.
·
Individual instruments may not be disassembled or modified in any way for any purpose. Any unauthorized
modification, for any purpose whatsoever, will be considered unintended and improper use, will void warranty and
cancel the manufacturer's liability. Unauthorized modifications can undo safety features, compromise system
specifications (such as ingress protection rating) and cause failure to comply with applicable laws, regulations and
directives.
·
If the product is defective or otherwise does not meet your requirements, please contact your Bronkhorst
representative for assistance or advice.
Restraining factors
The maximum operating pressure and the ingress protection rating (IPxx) of the complete assembly are equal to those
of the component with the lowest respective value.
Overview
Components
A. Pilot valve
B. Control valve
C. Flow controller
D. Actuation cable
E. 4 mm OD push fitting
F. 4 mm OD flexible tube*
G. Tri-Clamp clamp*
H. Gasket*
*) Not included in scope of delivery
This representation shows the ES-FLOW™ from the rear and assumes that the process liquid flows from right to left
through the flow controller and the control valve. Depending on the ordered configuration of the ES-FLOW™, the
normal flow direction may differ from this assumption, which affects the way in which the components are to be
connected in step 2a.
