brondell Swash SE600, Руководство пользователя

Страница: 23 / 90

21
NOTE: Do not sit on the seat when programming Special
Mode Operations. The process will not work while the seat
is occupied.
Seat Sensor Override
The Seat Sensor is activated at the factory by default.
Completing the following steps will bypass the seat
sensor located in the seat and allows the wash functions
and dry functions to operate without the sensor being
engaged. Use caution in this mode.
1. Unplug the Swash from the outlet.
2. Press and hold the Night Light and Rear Wash buttons
on the auxiliary control panel, and plug the Swash
back in while continuing to hold the two buttons down.
3. If the water tank is full, you will hear a total of two
beeps. You’ll hear one beep once the Swash has been
plugged back in. Keep holding the Night Light and
Rear Wash buttons down until you hear a second beep
(about five seconds later).
4. The second beep indicates that the Seat Sensor has
been overridden.
5. To reactivate the Seat Sensor, repeat Steps 1-3.
Activating/Deactivating Silent Mode
By default, the Swash will beep to confirm commands
from the remote control and auxiliary control panel.
Follow the steps below to silence the beeping sounds.
1. Press and hold the Night Light and Eco Mode buttons
on the auxiliary control panel
2. A beep will sound, indicating that Silent Mode has
been activated.
3. To deactivate Silent Mode, repeat Steps 1 and 2.
Steps 1 & 2
Steps 2 & 3
OPERATING THE SWASH
Special Mode Operations