bromic.com
4
IMPORTANT NOTES AND WARNINGS
!
WARNING
INSTALLATION
• Read all instructions before installing or using this
device.
• Use this device only as described in this manual. Any
other use not recommended by the manufacturer may
cause radio interference, fire, electric shock, or injury to
people.
• Improper installation, adjustment, or alteration and
failure to follow the warnings and instructions in this
manual could result in personal injury, or property
damage.
• The manufacturer is not responsible for any damage
that could happen from improper use. The
manufacturer emphasises that this controller should be
used in a responsible manner and that all procedures,
warnings, and safety instructions contained in this book
be followed strictly.
• The product must be located on surfaces which cannot
be damaged by high temperature. It must be placed in a
well ventilated location. It cannot be hermetically closed.
• The connection cables must be protected against any
accidental impacts.
• This device is not intended for use in outdoor or
kitchens, bathrooms, laundry areas and similar indoor
locations.
• Do not install the device directly near high humidity
areas or where exposed to water such as outdoor, or
indoor near a bathtub, shower or swimming pool.
• This device is not intended for use by people (including
children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction
concerning use of the appliance by a person responsible
for their safety.
• Keep packaging materials out of reach of children
• Children should be carefully supervised when they are in
the area of the device.
• Do not attempt to alter the device in any manner.
• Do not paint any surface of the device.
• Do not touch the device with wet hands at any time.
• Do not use or store flammable materials near this
device.
• Do not spray aerosols or flammable materials in the
vicinity of the device while it is in operation
• Never operate the device in an explosive environment
such as areas where petrol or other flammable liquids or
vapours are stored.
• This device must only be used on a 5 Volt DC
electrical supply. Correct polarity must be used or
the device will be damaged.
• This controller is NOT intended to be installed on
recreational vehicles and/or boats.
• Do not run cord under carpeting. Do not cover with
throw rugs, runners or the like arrange cord away
from traffic area and where it will not be tripped
over
• This Installation and Operation manual should
not be removed from the site of installation.
Installer should leave manual with the customer for
future reference.
• If the device has not been used, or will not be used,
for a long period of time, disconnect power supply
• This product does not require maintenance and
cannot be repaired.
• Installation must be carried out by a qualified &
licenced technician only.
• The device should be inspected before use and
at least annually inspected by a qualified & licenced
service person.
• If damage to the device is suspected, discontinue
use immediately and contact the supplier or
qualified person to replace.
• Device has no serviceable parts inside.
• Do not open the device.
• At the end of this product’s useful life, it must not
be disposed of as domestic waste, but must be
taken to a collection centre for waste electrical and
electronic equipment. It is the user’s responsibility
to dispose of this device through the appropriate
channels at the end of its useful life. Failure to do so
may incur the penalties established by laws
governing waste disposal. Proper differential
collection and the subsequent recycling, processing
and environmentally compatible disposal of
waste equipment avoids unnecessary damage to
the environment and possible related health risks,
and also promotes recycling of the materials used
in the appliance. For further information on waste
collection and disposal, contact your local waste
disposal service, or the place of purchase
ELECTRICAL CONNECTIONS
• Installation must be carried out by a qualified &
licenced technician only.
• The device requires the use of an AC to DC
transformer with 5 Volt DC output (not supplied.)
Correct polarity must be used or the device will be
damaged.
• Ensure all device wiring is separated from high
voltage wiring.
• Ensure all wiring is protected from high temperature
surfaces and correctly sized for the rating.
• IMPORTANT - Installation must be carried out by a
licensed and authorised person.
• The installer is to ensure that the requirements of the
local authority, local electrical installation code,
municipal building codes, and any other relevant
statutory regulations are carried out.
• After unpacking, make sure the device shows no signs
of visible damage or tampering. If the device appears
damaged, contact the place of purchase for assistance.
• Remove transit protection before use.
MAINTENANCE/ REPAIR
