RTU32N Installation and Wiring
Guide
Brodersen A/S, Islevdalvej 187, DK-2610 Roedovre, Denmark, Tel: +45 45 35 26 27, Fax: +45 45 35 26 29, Email: [email protected]
17
4
SG
Signal ground
GND
5
RX
Receive data
Input
6
NC
Not used
-
Ethernets (LAN1 and LAN2)
Ethernet interface connectors: RJ45 10/100BASE-Tx Fast Ethernet compatible.
It is recommended to use shielded network cables. And note that if you connect your PC directly to the LAN1 or LAN2 interfaces, you
may need to use cross-wired network cable (if your PC Ethernet interface do not support auto switching RX/TX).
Factory settings:
-
LAN1: 192.168.0.1 , Subnet: 255.255.255.0
-
LAN2: DHCP
Dual USB
Dual USB interface type 2.0. Use UCM-9x modem always in USB2 connector.
LocalBuses (LB1 and LB2)
LocalBus RJ45 connectors for Brodersen I/O expansion modules. The LocalBuses provide also power supply for I/O Expansion modules.
NOTE that load is limited to 600mA@12VDC. Consult data sheet for details.
7.
LB2 I/O modules
For configuring the system with LB2I/O please use our online configurator
The online configurator calculates the
power, and inform when additional power supply is needed. The online configurator is always updated with the available
types of I/O modules. The LB2 series support Hot-Sap and redundant Power supply options for the I/Os.