BRODA Elite Chairs
30
5.
Thread the new cable around the frame of the chair the same as the old one and install new cable ties
where necessary.
6.
Hook the end of the cable into the lever in the actuator and clip the cable housing into the actuator
housing.
7.. Install a new cable tie around the end of the cable housing and the actuator, if the chair was originally
equipped with one.
Note: This procedure may vary on earlier models.
7.4
6” Casters
Maintenance and Repair:
These casters are designed to be maintenance free. The bearings in these casters are permanently lubricated
and should not require further lubrication. There are no adjustments or repair for this caster. Should the
caster become defective, it must be replaced.
Replacement Instructions:
This caster has a stem that is inserted into the rear leg of the chair and is held in place by two mounting
bolts located above the caster on the front and rear of the rear leg of the chair. The caster functions are
controlled by pedals mounted on each side of the chair at the rear. These pedals control the function of
casters at the same time and are mounted on a hexagonal shaft that run through the frame of the chair from
one side to the other and are held in place by set screw located on the underside of the pedal. These casters
must be synchronized with each other during installation as per the following instructions.
Steps: