BRODA Elite Chairs
28
6.
Adjust the cylinder as per the above adjustment instructions.
Installing an Actuator
1.
Hold the small pin in your right hand, with the long flat side, and the “u” cut out
pointing upward.
2.
Hold the head of the actuator in your left hand with the tail portion pointing to the
right and the rounded head pointing up
3.
Slide the small end of the pin through the hole, bringing it through just until it
becomes flush with the side of the actuator
4.
Holding the pin in place, wind the cylinder into the actuator, making sure the pin
stays in place at all
times
5.
Tighten the actuator on the cylinder until the pin reaches the top of the hold in the
actuator.
6.
Using a wrench, tighten the bolt that will be located just underneath the attached
actuator
7.3
Cables and Handles