Brocade Communications Systems ICX 6430 series, Руководство по установке оборудования, Страница: 42 / 108

FIGURE 33 Stacking ports on the front panel of an ICX 6450 device
1. Console port
2. Slot 2 (SFP and SFP+ uplink or stacking ports)
3. Out-of-band management port
4. Slot 1 (10/100/1000 Mbps ports)
Ports 1 and 3 are default stacking ports. Default stacking ports have the capability to accept special stacking packets during a CLI-
initiated command sequence of the Secure Setup utility. If ports 1 and 3 are not used as stacking ports, you can use them as data ports.
Configuration is not required to use them as data ports.
All four ports in slot 2 can be used as stacking ports.
The stacking ports can be grouped into two trunks. Ports 1 and 2 can form a trunk; ports 3 and 4 can form another trunk. By default, ICX
6450 devices are not configured for trunking.
On the ICX 6450, ports 1 and 3 are 10 Gbps ports. Without a license at bootup, ICX 6450 ports 2 and 4 come up in 10 Gbps port
speed in an error disabled state. To enable ports 2 and 4 to 10 Gbps port speed, you must purchase the ICX6450-2X10G-LIC-POD
license. For more information about enabling ports 2 and 4 to 10 Gbps port speed, refer to the
FastIron Ethernet Switch Administration
Guide .
Trunking requirements
• You can connect one or both ports in a trunk. Connecting both ports in a trunk increases stacking bandwidth and provides
resiliency.
• If you connect both ports in a trunk, both ports must connect to both ports of one trunk on another device.
• When configuring a trunk, the ports in the same column are always trunked (port 1 to port 2, port 3 to port 4). One or both of
the two sets of stacking ports can be trunked (or untrunked).
• For ICX 6450 devices, all stacking ports must be configured to 10 Gbps port speed to enable trunking.
NOTE
If you use the Secure Setup utility to set up a mixed stack, the stacking units (ICX 6610 devices and ICX 6450 devices) are
automatically trunked.
Stacking configuration requirements
The stacking configuration requirements are describes in the sections below.
Connecting devices in a mixed stack
Brocade ICX 6430 and ICX 6450 Stackable Switches Hardware Installation Guide
42 Part Number: 53-1003617-03