4-2
ELECTRICAL HOOK-UP
Disconnect main power
supply and turn unit OFF
before installing power supply to the
unit. HIGH VOLTAGE may be encoun-
tered. Only persons trained and
equipped for checking high voltage shall
perform electrical connections.
Access For Hook-Up:
1. Disconnect main power supply.
2. Remove condensate pan and two
screws from bottom of front panel.
Pull out and down on bottom to
remove.
Phase Wiring:
Phase wiring diagram is located inside the
front panel.
Electric units are shipped from the factory
wired for 3 phase. In this case, applied
voltage must be connected to L1, L2
and L3 of contactor C1 and a ground
wire to the GND connector.
Unit Dimensions For Electrical Hook-Up:
Check all contactor screw
connections to be sure
they are fully tightened for proper electri-
cal continuity.
broaster.com Manual #17278 9/13 Rev 9/16
Содержание 2400 Series
