MODEL SPKACC
Page 2
INSTALLATION WITH “RAISED” MOTOR BRACKET
1.
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR
INJURY TO PERSONS: Switch power off at service panel
and lock the service disconnecting means to prevent power
from being switched on accidentally. When the service
disconnecting means cannot be locked, securely fasten
a prominent warning device, such as a tag, to the service
panel.
2. Remove fan
GRILLE by squeezing two GRILLE SPRINGS
and sliding them out of their mounting slots on each side of
the fan housing. Disconnect
LIGHT WIRE from fan (if fan is
equipped with a light). Set grille assembly aside for now.
GRILLE SPRING
GRILLE
LIGHT
WIRE
4. Partially install (2) #8-32 x 5/8 screws (included) into threaded
holes in speaker bracket - only so ends of screws are flush
with bottom surface of speaker bracket. Note: Installing
screws below flush will make the next couple of steps difficult.
5. Insert speaker into fan housing. Make sure
SPEAKER
BRACKET hooks over edge of BRACKET OPENING.
6. Make sure rear surface of speaker is located as close to
wall of fan housing as possible.
7. Turn
#8-32 X 5/8” SCREWS (partially installed in Step
3) until they make contact with
FAN PARTITION PLATE.
Alternately tighten both screws. DO NOT OVERTIGHTEN.
8. Insert
SPEAKER PLUG into power receptacle where
motor plug was disconnected.
9. Connect
FAN MOTOR PLUG into SPEAKER WIRE
RECEPTACLE.
10. Plug in
LIGHT WIRE (if applicable) and re-install grille that
were unplugged and removed in Step 2.
11. Turn on power to fan.
12. Go to
Bluetooth
®
Speaker Operation section for
Bluetooth
®
speaker operating instructions.
SPEAKER PLUG
3. Disconnect
FAN MOTOR PLUG.
BRACKET
OPENING
FAN PARTITION
PLATE
#8-32 X 5/8”
SCREWS
#8-32 X 5/8”
SCREWS
FAN MOTOR PLUG
SPEAKER WIRE
RECEPTACLE
FAN MOTOR
PLUG
