10
13. OPERATION
Always turn your hood on before you begin cooking to establish an air flow in the kitchen. Let the blower run for a few minutes to clear the
air after you turn off the range. This will help keep the whole kitchen cleaner and brighter.
NOTE: When pressed, the chosen push button beeps and its indicator lights up blue.
HC0085
B
LOWER
ON / S
PEED
INCREASE
PUSH
BUTTON
(D
OUBLE
FUNCTION
PUSH
BUTTON
):
Press one time on this push button to activate the blower at low speed, a second time for medium speed and a third time for high
speed.
NOTE: When blower is turned on, 100% of power level is activated during 1 to 2 seconds acting as a “kick-start”. It will then operate
at the desired setting.
B
LOWER
OFF / S
PEED
DECREASE
PUSH
BUTTON
(D
OUBLE
FUNCTION
PUSH
BUTTON
):
Press on this push button to lower the blower speed. If need be, press until the blower stops.
D
ELAY
SETTING
PUSH
BUTTON
:
To set delay, press this push button when blower and/or lights are in use. Blower and/or lights will continue to operate for 10 minutes
and then will stop automatically (the delay setting push button indicator will blink during the 10 minutes to indicate that the delay has
been activated). To cancel delay function, press on this push button again, the blower and/or lights will continue to operate and won’t
stop until Blower OFF / Speed decrease push button and/or Lighting push button is pressed.
L
IGHTING
PUSH
BUTTON
:
Press once on this push button to turn the lights on. Press once more to turn the lights off.
14. CARE
Grease Filters
Grease filters should be cleaned frequently. Use a warm dishwashing detergent solution to clean the filters.
Clean all-metal filters using a non-phosphate detergent. Discoloration of the filters may occur if using phosphate detergents, or as a result
of local water conditions - but this will not affect filter performance. This discoloration is not covered by the warranty. To minimize or prevent
discoloration, hand wash filters using a mild detergent.
Non-ducted Filters
Change the non-duct recirculation filters every 6 months. Rotate the filters to remove them from the blower and replace; purchase
S97018030 or ROUNDFILTER.
Hood Cleaning
Stainless Steel Cleaning:
Avoid when choosing a detergent:
- Any cleaners that contain
bleach
will attack stainless steel.
- Any products containing:
chloride, fluoride, iodide, bromide
will deteriorate surfaces rapidly.
- Any combustible products used for cleaning such as
acetone, alcohol, ether, benzol
, etc., are highly explosive and should never be
used close to a range.
Do:
• Regularly wash with clean cloth or rag soaked with warm water
and mild soap or liquid dish detergent.
• Always clean in the direction of original polish lines.
• Always rinse well with clear water (2 or 3 times) after cleaning.
Wipe dry completely.
• You may also use a specialized household stainless steel
cleaner.
Don’t:
• Use any steel or stainless steel wool or any other scrapers to
remove stubborn dirt.
• Use any harsh or abrasive cleansers.
• Allow dirt to accumulate.
• Let plaster dust or any other construction residues reach the
hood. During construction/renovation, cover the hood to make
sure no dust sticks to stainless steel surface.
