Testing & Maintenance
5.1 Testing
Batteries have been installed before delivery. Before testing, you need to register the RC10 codes to the wireless products.
Please check the setting details from wireless products installation user manual. Testing procedure is as follows:
1, 3 meters away from target receiver, press the button with closed padlock pattern in RC10;
2, Ensure wireless device give the same voice prompts, such as "the system is armed" etc;
3, Check the voice prompts in some blind spots where wireless devices signals can reach, such as the place
that transmission is blocked by wall & large objects, or the place that influenced by structural materials.
5.2 Battery Replacement
When signal transmission is weakened or LED lights dimmed, users need to
buy replacement batteries (Type: R2032 3V lithium battery).
Please replace the batteries accordingly:
1, Take out the small screws in the back of remote control with a small
Phillips screwdriver, being careful not to lose the screws;
2, Open the rear cover from the screws place, and remove the old batteries;
3, Insert new batteries, positive pole outward (as picture);
4, Install the rear cover and hanging ring, then fixed with screws;
5, New batteries testing: press one button, LE D lights on the remote
control flashes, meanwhile, the host can give corresponding response.
V. System
Limitations
Our wireless alarm systems have been developed very reliable. While, because of their low point transmission capacity and limited range will make
the systems be restricted within a certain range. Followings are the situations that may occur:
The signal of receiver will probably be obstructed or out of the selected frequency range;
①
②
Wireless device should be tested regularly to check whether there is any conflict; we advise to test once every week;
③
Unstable voltage of host or low voltage of remote control may cause failure of signal transmission;
For any support, please
contact
us for technical service
:
