Broadcom Symantec SA-STAG8-2U144, Быстрый старт

Страница: 4 / 4

SA - STAG8-2U144, SA - STXG8-2X144, SA - STAG8-5U840
4
Security Analytics Gen14 Dell Storage Quick Start Guide
Broadcom reserves the right to make changes without further notice to any products or data herein to improve reliability, function, or design. Information furnished by Broadcom is believed to be accurate and reliable. However, Broadcom does not assume
any liability arising out of the application or use of this information, nor the application or use of any product or circuit described herein, neither does it convey any license under its patent rights nor the rights of others. (2020.10.02, 17:22:01)
5 — Power On the System
When powering on Sensor Systems, make sure that
components are powered on in the following order:
1. Power on any expansion enclosures (SA
- STXG8-2X144).
Wait until the expansion enclosures’ drive lights are lit
(solid) before proceeding.
2. Power on the storage arrays (SA - STAG8-2U144 or
SA - STAG8-5U840). Wait until storage arrays’ drive lights
the are lit (solid) before proceeding.
3. Power on the server (SA - SRVG8-20 or SA - SRVG8-40).
4. Once all components are powered on, verify the following:

For the SA - STAG8-2U144 and SA - STXG8-2X144, the
System Power LED turns green.

For the SA - STAG8-5U840, the Power On/Standby
LED turns green.
6 — Configure Network Settings
for the Storage Array
1. Connect an Ethernet cable to the storage array’s
Network port on Controller A . Connect the other end of
the cable to a laptop with an IP address of 10.0.0.1/24
and a default gateway address of 10.0.0.2.
2. Select the User Language and click Get Started .
3. Enter a Username and Password and click Apply and
Continue . The Username will be required when
configuring the storage array’s disk and filesystem for
Capture and Indexing.
4. When prompted with the Welcome screen, click System
Settings .
5. Configure the Controller A settings for IP Address , IP
Mask , and Gateway .
6. Configure the Controller B settings for IP Address , IP
Mask , and Gateway .
7. Click Apply and Close and proceed to configuring the
storage array from the Security Analytics server’s CLI.
7 — Next Steps

If you have not done so already, configure the Sensor
(server) per the instructions in the
Security Analytics
Gen14 Dell Server Quick Start Guide
, available at:
techdocs.broadcom.com

Configure the storage array’s Capture and Indexing
volumes from the Sensor’s CLI. For instructions, see the
Security Analytics Gen14 Dell Configuration Guide
,
available at: techdocs.broadcom.com
Symantec Technical Support

For Symantec Technical Support, case management,
licenses, and product downloads, go to
support.broadcom.com/security
Security Analytics Help and Documentation

For Security Analytics help, in the web UI, select
Settings > Help > [language].

For Security Analytics software documentation, go to
techdocs.broadcom.com and type “Security” in the
search field, then click Security Analytics .
Storage Documentation

For Symantec storage array documentation, go to
techdocs.broadcom.com and type “Appliances” in the
search field, then click Hardware Appliances .

For Dell PowerVault storage documentation, go to
dell.com/storagemanuals and navigate to your storage
model ( PowerVault ME4012 , ME4084 , or ME412 ).