Broadcom Symantec SA-STAG8-2U144, Быстрый старт

Страница: 3 / 4

Security Analytics Gen14 Dell Storage Quick Start Guide
SA - STAG8-2U144, SA - STXG8-2X144, SA - STAG8-5U840
3
4 — Connect Cables
The following deployment documents a Sensor System with a
single sensor (SA - SRVG8-20 or SA - SRVG8-40) connected to
a storage array (SA - STAG8-2U144) with up to three expansion
enclosures (SA - STXG8-2X144). For information on other
deployments, see the Security Analytics documentation at:
techdocs.broadcom.com
NOTE: Network cables are not included with the storage
array. Make sure to use only straight-through Ethernet
cables. Category 5E cables or better are recommended for
1000Base-T operation. Category 6A cables are
recommended for 10GBase-T operation.
NOTE: For SAS connections, use the 12Gb HD-Mini to HD-
Mini SAS cables included with the storage array, or equivalent.
1. Connect the storage array to the management network:

Connect an Ethernet cable to the storage array’s
Network port on Controller A . Connect the other end
of the cable to the management network.

Connect an Ethernet cable to the storage array’s
Network port on Controller B . Connect the other end
of the cable to the management network.
2. Connect the storage array to the sensor:

If the sensor has one RAID controller (see Figure 1 ):
– Connect an SAS cable to the storage array’s SAS 0
port on Controller A . Connect the other end of the
cable to the sensor’s SAS 0 port (RAID 1).
– Connect an SAS cable to the storage array’s SAS 0
port on Controller B . Connect the other end of the
cable to the sensor’s SAS 1 port (RAID 1).

If the sensor has two RAID controllers, connect the
following cables as well (see Figure 2 ):
– Connect an SAS cable to the storage array’s SAS 1
port on Controller A . Connect the other end of the
cable to the sensor’s SAS 0 port (RAID 2).
– Connect an SAS cable to the storage array’s SAS 1
port on Controller B . Connect the other end of the
cable to the sensor’s SAS 1 port (RAID 2).
3. Daisy-chain up to three expansion enclosures from the
storage array’s SAS_EXP ports (see Figure 3 ).
4. Connect the included power cords to the storage array’s
power inlets. Connect the other ends of the cords to
separate power distribution systems.
SAS Cabling Examples
NOTE: For additional deployments and cable configurations,
see the Security Analytics Gen14 Dell Configuration Guide ,
available at: techdocs.broadcom.com
Figure 1: (1) SA - SRVG8-20 (1 RAID Controllers),
(1) SA - STAG8-2U144
Figure 2: (1) SA - SRVG8-20 (2 RAID Controllers),
(1) SA - STAG8-2U144
Figure 3: (1) SA - STAG8-2U144 (2 RAID Controllers),
(1) SA - STAG8-2U144, (3) SA - STXG8-2X144s