Broadcom Brocade X7-8, Руководство по установке

Страница: 65 / 212

X7-8-Install-IG100 Installation Guide Brocade
®
X7-8 Director Hardware Installation Guide
•
ICL topologies
•
ICL trunking
•
Configuring ICLs between X7 Directors
•
Configuring ICLs between X7 and DCX 8510 Directors
•
Configuring ICLs between X7 and X6 Chassis
Brocade 4x32Gb/s 2-Km LWL QSFPs
The Brocade 2-km 4x32Gb/s LWL QSFP28 is a hot-swappable, low-voltage (3.3V) digital diagnostic optical transceiver
that supports high-speed serial links over parallel single-mode optical fibers at signaling rates up to 4×28.05Gb/s. This is a
multi-rated CWDM4 QSFP28 transceiver with a duplex LC connector, as in the following illustration. It supports up to 2-km
link length using duplex single-mode fiber.
Figure 19: QSFP28 Transceiver
1. Pull Tab
2. QSFP Cable
3. QSFP Transceiver
All 16 ICL ports can be used for 2 km distances when 20 buffer credits are configured per virtual channel.
Time and Items Required
The installation or replacement procedure for one transceiver takes less than 5 minutes. Ensure that the following items
are available:
•
Required number of compatible power cables
•
Required number of supported Brocade-branded transceivers
•
Required number of compatible fiber-optic cables
Precautions Specific to Transceivers and Cables
DANGER
Use only optical transceivers that are qualified by Broadcom and comply with the FDA Class 1 radiation
performance requirements defined in 21 CFR Subchapter I, and with IEC 60825 and EN60825. Optical products
that do not comply with these standards might emit light that is hazardous to the eyes.
CAUTION
Do not use the port cover tabs to lift the module. They are not designed to support the weight of the module,
which can fall and be damaged.
X7-8-Install-IG100
65
Broadcom