LBH-SDI-EAD-T User’s Manual
Link Bridge
TM
HDBT SDI Video Converting Transmitter System
Broadata Technical Support, [email protected]
11
2.0 SETUP
LBH-SDI-EAD-T is a transmitter that can be paired with any DVI/HDMI
centric LBH receiver (such as LBH-HDMI-R). One LBH-SDI-EAD-T
transmitter unit is located at the near-end and connected through one
CAT-5e/6, to the LBH-HDMI-EAD-R receiver located at the far-end of the
link. Figure 2-1 depicts a typical installation for the LBH-SDI-EAD-T.
Figure 2-1
LBH-SDI-EAD-T/R Setup
2.1 Mounting
Before installing the units into your housing, make sure there is
enough space to pull and connect both the electrical and
CAT-5e/6 transmission cables without stressing them beyond
the manufacturer’s limitations (also known as the minimum bend
radius).
2.2 Cabling and Connectors
In order to setup the LBH-SDI-EAD-T properly, make sure to
observe the following instructions when installing the proper
cables. The LBH-SDI-EAD-T requires two parts to the cabling
setup, the electrical and the CAT-5e/6 transmission.
