LBH-H-T/R-EAD-ICP User Manual
Link Bridge
TM
HBaseT HDMI Transmission System w/External Audio and Inline Control Processor
Broadata Technical Support, [email protected]
9
12. SW:
The unit configuration dip switch
13. IR Learner:
Built-in IR receiver for IR learning.
14. IR Learner LED:
Lighted when the unit is IR learning mode.
15. CONFIG:
Configuration/keypad port
16. LAN:
Ethernet connector.
17. RESET:
Press the button to reset the device back to factory
default settings.
3.0 CONNECTOR PINOUT ASSIGNMENT
3.1 Extender
3.1.1 Serial Data Interface
Each LBH-H-EAD-ICP unit can be used for RS-232 and IR
interface.
RS-232/ IR Data
The LBH-H-EAD-ICP transmits two channels of data
signals. Follow the procedures for installing data terminal
devices.
1. Label and connect one serial data cable to the user’s
RS-232 or IR device.
2. Connect the other end of this cable to the front panel
data terminal block connector on the
LBH-H-EAD-ICP (see below).
RS-232/IR Terminal block pinout
