LBH-H-T/R-EAD-ICP User Manual
Link Bridge
TM
HBaseT HDMI Transmission System w/External Audio and Inline Control Processor
Broadata Technical Support, [email protected]
27
Configure IR Code
The
Configure IR Code
page is used to learn and manage IR codes in
the ICP. To learn an IR code, type in the label of the IR code in
New
Label
and click the
Learn
button. Once IR Learn mode is initiated, the
user needs to present an IR signal to the IR receiver port within 30
seconds. If a valid IR code is not presented within 30 seconds, the IR
learn process will timeout and the process will need to be re-initiated.
After an IR code is learned successfully, it will be stored in memory and
appear in the
IR Preset
drop down menu. To test a learned IR code,
select the IR code from the IR Preset menu and click
Test
button.
Verify that the IR code works correctly on the target device. To delete
an IR code from the IR Preset menu, select the desired IR code and
click the
Delete
button.
On the top menu click
Configure
and then click
IR Code
.
The following
page will be displayed:
