The first method is to press the "Adv.Period" [9] control key and jump into the next "Auto-
Program" period immediately. (e.g. if you come home earlier than usual, use this to move
out of "Leave" and into "Return").
Whenever you do this, that key [9] changes to read "Cancel/Adv.Period" so pressing it will
take you back to the period you were in.
The Networker will return to its Auto-Program as soon as it reaches the next period.
The second method is to use the ROTARY DIAL [2] and increase or decrease the current
temperature setting.
With this method, the "Adv.Period" key has now become the "Cancel" key [9]. So pressing it
will return you to the Auto-Program.
(For those with zone dampers, altering the zone setting will also result in a "Temporary"
[18] change).
If the preset "Auto Program" settings do not suit your lifestyle, you may wish to change
them. If so, read on.
Changing the Auto-Program Settings.
If your lifestyle doesn't match the pre-set AUTO-PROGRAM, those settings can be changed
very easily.
If you wish, you can change the time or the temperature for any period in four simple steps.
The first will take you into programming mode.
(a) Entering a Program.
If you are not already in heating mode, press the MODE key [4] until the word "Heater" [4a]
appears.
Then press the PROG key [3] and you'll notice the word "program" [5a] and the time [11]
will begin to flash.
(b) Selecting the Days to be Changed.
For your convenience, the Networker combines all the weekdays into one block and both
days of the weekend into another block.
The DAY key [10], is used to select which block you wish to program.
On the left of the screen, the weekdays are listed as a block [10a]. Just below them will be
the weekend block.
(c) Selecting the Period to be Changed.
Press the PERIOD key [9] to select the period you wish to change.
It starts with the WAKE period so the word "Wake" [9a] appears on the left of the screen.
