OPERATING INSTRUCTIONS
Airflow direction control
Adjust the air flow direction as required so as not to
cause discomfort to the occupant or cause uneven
room temperatures.
Adjust the horizontal/vertical louvers using the remote
control.
To set the horizontal/vertical air flow direction
Perform this function while the unit is in operation.
Use the remote control to adjust the air flow direction.
The vertical/horizontal louvers change 6 degrees in angle
for each press of the button. The louver can also be
set to swing automatically.
Please refer to the Remote Control Manual for details.
:
WARNING
IMPORTANT
: Please do not insert your fingers or other
objects into the unit.
The rotating supply air fan inside
may cause damage or injury.
Do not operate the unit for extended periods with the
air flow direction set downward in cooling or
dehumidifying mode. Condensation may form on the
surface of the horizontal louver causing moisture to
fall from the unit.
When the unit is restarted immediately after being
turned off, the louvers may not respond for up to
10 seconds as they reset their position.
The angle of the horizontal louver should not be set
at an overly acute angle, as this may reduce
performance as a result of restricted air flow.
The horizontal louver should not be positioned by hand.
This will force the horizontal louver out of sync. If this
occurs, please isolate the power supply for 10 seconds,
then restart the unit.
Do not operate the unit with horizontal louver in the
closed position, this will cause a malfunction due to
restricted air flow.
CAUTION
Manual operation can be used temporarily in case the remote control is disabled or
the unit requires service/maintenance.
OPERATING INSTRUCTIONS
Manual operation
NOTE: This manual does not include information regarding the Remote Control, please
see the Remote Control Manual, which is packed with the indoor unit.
Operating temperature limits
Manual control button
Suspension bars
Manual control button
AUTO/COOL
AUTO/COOL
（ ）
1
（ ）
2
Range
Range
Open and lift the front panel up at an angle
until it clicks and remains in place.
One press of the manual control button will
start forced AUTO operation. If pressed
twice within five seconds, the unit will
operate under forced COOL operation.
Close the panel firmly to its original
position.
This button is used for testing purposes
only. Do not use it for normal operation.
To restore to the remote control operation,
use the remote control directly.
CAUTION:
1
3
2
NOTE:
The unit must be turned off before
using the manual control button. If the
unit is operational, hold down the manual
control button until the unit is off.
Mode
Temperature
Room temperature
Outdoor temperature
1. Optimum performance is achieved within these operating temperature limits. If the unit
is used outside the above limits/conditions, certain safety protection features may be
brought into operation and cause the unit to not function as intended.
2.
Room relative humidity must be less than 80%. If the unit operates in an environment in
excess of this value, the surface of the unit may attract condensation. In this case, please
set the vertical air flow louver to its maximum angle (vertically to the floor), and set the
fan speed to HIGH.
NOTE:
Cooling
Heating
Drying
17 C
0
0 C ~ 50 C
0
0
-15 C ~ 30 C
0
0
10 C
0
0 C ~ 50 C
0
0
30 C
0
