OPERATING INSTRUCTIONS
OPERATING INSTRUCTIONS
8. Interconnecting refrigerant pipe (supplied
by installer)
9. Interconnecting wiring cable (supplied by)
installer)
10. Stop valve
Outdoor unit
Outdoor unit
LED Display Window
Indicating lamp on LED Display window
1. Front panel
2. Air inlet
3. Air filter (Behind front panel)
4. Air outlet
5. Horizontal air flow grille
6. Vertical air flow louver (internal)
7. Display window
Signal receiver
Indoor unit
Indoor unit
Special functions
NOTE:
The pictures in this manual are for
explanation purposes only. Your air
conditioner may differ slightly.
Vertical Swing Function
When the unit is turned on, the users can control the swing of the vertical louver swing by
the button on the remote control.
9
10
8
OPERATION indicating lamp
This lamp is illuminates when the air
conditioner is operating.
TIMER indicating lamp
Lit during Timer operation.
DEFROST indication lamp
Lights up when the units enters the defrost
cycle automatically or when the warm
air control feature is activated in heating
mode.
Temperature indicator
Displays the temperature settings when the
unit is operating.
Displays the troubleshooting fault codes.
Self Clean Function
This function operates after the unit has been in cooling mode to clean the Evaporator
and keep it fresh for the next operation.
The unit will operate in the following sequence :
1 - FAN ONLY mode at Low fan speed
2 - HEATING mode at Low fan speed
3 - FAN ONLY operation
4 - Stop Operation
5 - OFF.
Note:
This function is only available in COOL (AUTO COOL, FORCED COOL) and DRY modes.
Before selecting this function, it is recommended to run the unit in Cooling mode for
approximately 30 minutes. Once the Self Clean function is activated, all TIMER
settings will be cancelled.
In Self Clean mode, if the SELF CLEAN button on the remote control is pressed,
the unit will stop and turn off automatically.
Louver Angle Memory Function
Upon restarting the unit, the angle of the horizontal louver will automatically return to
the same position set last time.
In the following circumstances, the louver will return to the standard angle:
1) Pressing the turbo function or manual control button.
2) Turning power off and on to unit
3) Unplugging the unit (if applicable)
Refrigerant Leak Detection
With this technology, the LED display window will display “EC”. The indicating lamp will
continue to flash when the outdoor unit detects a potential refrigerant leak.
