Brivis B063047, Руководство по установке

Страница: 15 / 20

14
- One Brivis Gas Ducted Heater
- One Brivis Gas Ducted one Evaporative Cooler
- One Brivis Gas Ducted one Add-On
3.9 System with Zones (Inc. Brivis ZonePlus)
For systems installed with zones, the Brivis Touch Controller
parameters need to be changed. The appliance cannot be started
until all system zoning parameters have been programmed. Once
the zoning parameters have been programmed the system may be
run in either Manual or Schedule mode.
For specific appliance
installation parameters refer to the relevant appliance installation
manual and appendix contained within for zoning parameters.
Refer to Brivis ZonePlus manuals for detailed information on
STSP or MTSP systems or contact Brivis Technical Support.
3.10 System Operation
Instruct the home owner on system operation including:
 System design – MTSP or STSP
 Zone identification
 Minimum / maximum no. of simultaneous zones for design
conditions for Heating and Cooling (if fitted)

Common Zone operation (if applicable)

Constant Zone operation (if applicable)

Operating the system in manual mode
 Auto Operation – programming the Comfort Schedule
3.11 Service Notification Message
When the operating hours logged for an appliance exceeds the
predetermined period, the Brivis Touch Controller displays the
following:
Diagram 21 : System Alert
Pressing the “ ” icon will result in the following message being
displayed for either Heater or Evap Cooler fan run hours above
limit, refer Diagram 22.
Note : For Add-On Refrigerated Cooling connection, heater
parameters (H01) must be programmed.
The Spanner icon appears flashing
at one second intervals.
The “ ” icon is displayed with the Alert text flashing
at one second intervals.