Britton SafeWay, Инструкция по эксплуатации

Страница: 8 / 54

8
3. RECLINING THE CARSEAT
The car seat can be used in five positions: Lift the handle (S) under the front of the seat up and
pull or push the shell forwards or backwards. Release the handle in the required position and
push until you hear a distinct click (Fig.2).
4. HARNESS ADJUSTMENT
The correct height of the shoulder belts is attained when the belt disappears into the
shell slightly above the shoulder of the child.
The shoulder harnesses can be set to four heights and must be passed through the holes clos-
est to the shoulders of your child. If the shoulders of your child are between two pairs of holes,
use the higher ones.
4.1 Loosen the shoulder belts by pressing the release button (Q) and pulling the shoulder belts
(N) as far as you can. Note! Do not pull the belt pads (M) .
4.2 Adjust the baby car seat into the sleeping position.
4.3 Remove the shoulder belts (N) from the belt anchor (H). (Fig. 3).
4.4 Pull the shoulder belts (N) through the shell and the cover, then place them at the desired
height using the same slots in both the cover and the actual seat (Fig. 4).
4.5 Place the shoulder belts (N) through the belt pads (M), the head pillow (K), the cover (A)
and the seat and reattach them to the metal anchor (H) (Fig. 5).
If you wish to alter the belts from or to the lowest position, place the baby car seat in the sleep-
ing position.
If you wish to alter the belts from or to the second or the third or highest position, place the
baby car seat in the sitting position.
5. SECURING YOUR CHILD USING HARNESS
5.1 Loosen the shoulder belts (N) by pressing the release button (Q) and pulling the shoulder
belts (N) as far as you can. Note! Do not pull the belt pads (Fig. 6).
5.2 Open the belt buckle (O) (Fig. 7) and place the belts (N) over the sides of the shell (Fig. 8).
5.3 Put your child comfortably with his/her back against the shell and make sure that there are
no toys or other hard objects in the shell (Fig. 9).
5.4 Slide buckle tongue sections together and insert them in the buckle with an audible “ click”
(Fig. 10).
5.5 Pull the shoulder belts (N) tight, pull the remaining slack out of the belt system and pull the
belts tight by the adjuster belt (R) (Fig. 9).
Caution! Do not twist or interchange the shoulder straps.
6. SAFETY NOTES!
Tightening the harness (Fig. 9)
Pull the adjusting belt (R) straight towards you, not upwards or downwards.
Please pay attention to the adjusting belt (R). Whilst travelling (especially outside the car) it
should always be attached to the cover.
Before start driving always check that:
The shoulder straps of the car seat are comfortable but firm fit around your child.
The shoulder straps are adjusted correctly.
The shoulder straps are not twisted.
The buckle tongues are engaged in the harness buckle (Fig. 10).
7. INSTALLING IN VEHICLE
Please do not leave your child unattended in the child safety seat in the vehicle.